Mechanical, Electrical, Plumbing (MEP) and Handyman Services in Pakistan

Every building needs good and well-maintained electrical, mechanical, fire, and plumbing prevention systems in order to ensure the building’s longevity. The designing of these crucial systems is very articulate and requires careful planning and execution. It is a specialized job that is done best by MEP service providers.

Our MEP crew is well experienced in making MEP BIM mockups and customizing them to suit the design and infrastructure of the buildings. They work closely with customers and are well versed in various codes like NFPA, ASHRAE, and IPC which effectively makes the job easy.

Our MEP Solutions & Handyman Services Broadly Include the Following:

Electrical

• Lighting design
• Designing services emergency lighting
• Load circulation detailing
• MV/LV electrical distribution
• Designing services for Electrical power plans
• Single line diagram and distribution of electrical power
• Calculation of fault levels
• Cable selection and calculation of drops in voltage
• Grounding and earthing systems
• Fire protection systems
• Lighting protection systems
• Designing of low voltage systems

Plumbing

• Gas service planning
• Designing of fuel gas piping
• Calculation of hot and cold-water capacity
• Calculation of pipe sizes for installation
• Layouts of water services
• Schematics for water services
• Schematics soil and waste
• Designing of gravity-based waste and soil systems
• Layouts for waste and soil system
• Datasheet compiling for plumbing equipment
• Layouts for medical gas and vacuum piping
• Design requirement document preparation
• Sizing and selection of water storage tanks, pumps, calorifiers
• Insulation selection for piping materials
• The layout of the plant room

Fire Prevention Services

• Layout drawings
• Sprinkler, smoke detection, and suppression systems for gas
• Designing and preparing schematic diagrams
• Calculating water storage capacity & pump sizes
• Stormwater and discharge unit calculations
• Calculating gas quantity needed by fire control systems
• Specification designing
• Designing and preparing layouts for sprinkler and water systems
• Services for storm and sewage water

Heating, Ventilation, and Air Conditioning (HVAC) Services

• Schematics for chilled water
• Selection for HVAC equipment
• Stairwell and lift well pressurization systems
• Calculations for heat loads
• STP room and panel room ventilation
• Underfloor heating systems
• Drawings for duct layouts
• Tunnel ventilation
• Systems for chilled beams
• CFD analysis and basement ventilation
• Designing for plant room layouts.